Lenco 101 Standard Actuator - 12V - 2-1/4" Stroke

101 Standard Actuator

Included in Standard Trim Tab Kit, Standard Performance Tab Kit and Bennett Retrofit Kit

5/16" (.79 cm) mounting hardware
Stroke: 2-1/4" (5.72 cm)
Length overall: 12-1/8" (30.80 cm)
Length pin to pin: 11-1/2" (29.21 cm)
Diameter (upper housing): 2-1/2" (6.35 cm)
Mounting hardware: 5/16" ( .79 cm) or Delrin Pin (Part #121)

Part # (Superseded #)
#15054-001 (101-2), 12 Volt w/6' (1.83 cm) cable with Deutsch connector & mounting hardware (replacement length)

• Top cap gland seal sheaths the actuator cable outer jacket as well as both internal conductors for maximum waterproofing
  
• Corrosion proof Vandar mounts
  
• Stainless steel ram won't flex, even under extreme loads
  
• Double O-ring for maximum protection
  
• Ballscrew rotates freely on 12 ball bearings at both ends of its stroke so there's no need for complicated limit switches and clutches
  
• Self-locking ballscrew locks into position and will not drift
  
• Precision molded, powdered metal, high alloy gears provide high accuracy, high wear resistance, and high strength for long life
  
• Tough, high-torque motor easily transfers 750 lbs
  
• High-impact, ultraviolet resistant nylon 66, 50% glass fiber reinforced thermoplastic housing
  
• Corrosion proof Vandar cap and mount, stands up to severe loads